Auction RC Flail Mower Becomes a Robot That Mows by Itself Using a Drone Flight Controller

User Avatar Aswinth Raj
Author
Share
Autonomous RC Flail Mower Cutting Grass Field

YouTuber jakkuh has about 5 acres of farm grass that has to keep getting cut, and after spending several full days on a ride-on mower he decided a robot should do it. His build video, which passed 170,000 views within a day, takes a remote-control tracked flail mower bought at a local auction and turns it into an autonomous mower that follows a GPS path. He did it with parts usually found in drones.

Starting point: an RC mower

The first auction machine had a 20-inch deck. His own maths put 5 acres at about 15.5 hours of mowing at 2 mph, so he went back to the auction and came home with a bigger tracked unit carrying a 48-inch flail head. Its engine drives the flail, while two DC motors with their own motor controllers drive the tracks from two 12 V batteries in series, a 24 V system. Power is switched by a big relay fed from the ignition key, and the original RC receiver sends PWM signals to a small converter board that the scooter-style motor controllers understand. That made it a good candidate: the machine was already drive-by-wire, it just needed a smarter brain.

The drone parts that drive it

  • Flight controller: a Pixhawk 6C Mini running ArduPilot's rover firmware replaces the RC receiver and outputs the drive signals
  • Positioning: a WitMotion UM982 dual-antenna GNSS receiver with two u-blox antennas; the second antenna gives true heading, not just position
  • Manual override: an SBUS RC receiver so he can still take over with a handheld transmitter
  • Relays: an 8-channel relay board lets the flight controller cut the main power relay, so he can stop the machine remotely
  • Wi-Fi link: an ESP32 running DroneBridge acts as a Wi-Fi telemetry bridge to the ground station, with a 5G travel router on board for range
  • Power: a PM02 converter supplies clean 5 V, wired upstream of the main relay so the controller stays alive when the drive power is cut

What went wrong first

The first night test was chaos: the tilt cut-off kept disarming it, the compass heading was off, and it made wide wrong-way turns. The fixes were classic rover tuning. He entered where the GPS antennas sit relative to the centre of the machine, calibrated the dead zone of the motor controllers, and remounted the flight controller in a rigid box, because when GNSS drops out the controller has to fill the gaps from its own sensors. He also dropped QGroundControl and vibe-coded his own simple mission planner. After that it mowed straight back-and-forth stripes for hours, straighter than he could drive by hand.

It is not a product, and he says plainly that it has no proper safety systems yet. Lidar or obstacle sensing is next on the list. As a recipe, though, an RC machine plus an ArduPilot flight controller and dual-antenna GNSS is a practical route to an autonomous ground robot. For another build that uses RTK GPS, see this open-source radar mapping drone.

Image credit: jakkuh, frame from the build video, cropped and resized.

About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn

Have any question related to this Article?

Add a comment

No account needed. Your comment appears once a moderator has reviewed it.

Never shown publicly.
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.