Sony's Mavica cameras saved digital photos straight onto 3.5-inch floppy disks, which was brilliant in the late 1990s and is a real nuisance now that almost no computer has a floppy drive. bigcrimping fixed that with floppy3.5, a battery-powered pocket box with a slimline floppy drive inside. Insert a full disk, press READ, and every photo is copied to a micro-SD card and shown on a web page over Wi-Fi, so you can swap in a blank disk and keep shooting.
Two processors, one board
The interesting part is how the custom PCB splits the job. An RP2354A microcontroller drives the 26-pin slimline drive and speaks the Greaseweazle host protocol, the open-source standard for reading floppy disks at the magnetic flux level. Because it uses that protocol, the same controller also works with the regular Greaseweazle gw tool over its second USB port.
An ESP32-S3 module with 16 MB flash and 8 MB PSRAM acts as the bridge. It controls the RP2354A over a custom SPI link, decodes the disk itself, writes the files to a /DISKnnnn/ folder on the SD card and serves them at floppy.local. It reads any FAT12 1.44 MB disk, so it is not limited to Mavica cameras, and both chips can be updated over the air.
Power and parts
The board also carries everything needed for a portable gadget: a BQ25180 charger and MAX17048 fuel gauge for a 1S LiPo of about 4000 mAh, an LTC2954 power button controller, a TPS63020 for 3.3 V and a TPS61022 boost converter for the 5 V the drive needs, an RV-3028 real-time clock and SN74LS07 buffers on the drive lines. A 1.9-inch ST7789 IPS screen on the lid shows status. One detail worth noting: the board will not start on USB alone, because the voltage drops too far when the drive spins up, so the battery must be fitted.
The first prototype was an ESP32 dev kit, a Greaseweazle-type adapter and a desktop floppy drive. The finished version has the gerbers, schematic, assembly drawing, printable case and both firmwares on GitHub. For a related build that serves files from an SD card over Wi-Fi, see our guide to running offline Wikipedia on an ESP32-S3.
Image credit: bigcrimping, frame from the maker's video, cropped and resized.
About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn
Add a comment
No account needed. Your comment appears once a moderator has reviewed it.