Arduino Electronic Load

Submitted by Eduardo on Sun, 09/27/2020 - 04:12

Did anyone built the Electronic load showed in https://circuitdigest.com/microcontroller-projects/adustable-electronic…?

There is inconsistency between the pictture/video and the article/schematic ... I'm not seen in the picture and in the video the R12 and R13

Also the gebber file dont have it

Also in the video the author says 555 connect direct to IRF, while showing the diagram that shows the resistor there.

Any ideia? Any help is welcome.

During the test process the Both Resistors are removed and connected directly. However, you can use the resistors, it will not be a problem.

  Joined February 12, 2018      696
Monday at 02:11 PM

Thanks for the reply, I appreciate.

If possible would be good to fix the gebber file, so the PCB will have space for the resistores and will be consistent with the rest.

To put the resistores on the actual PCB will be a little chanlenger.

 

  Joined September 27, 2020      1
Sunday at 04:04 AM

The board gerber is perfect... You just add the components it will work. The gerber is provided after testing the circuit.

  Joined February 12, 2018      696
Monday at 02:11 PM