D My encoder needed a pull-up on the switch. I had to swap the A and B signals from it as well. The square wave output is not toggling until I turn the encoder backwards a step. Is this expected? I am getting a sine wave out, but at a much lower frequency: setting at 1000Hz, I get a sinewave of 6.8Hz (after adding a 1uF cap). Is this expected? Thanks! David Mar 3, 2019
My encoder needed a pull-up on the switch. I had to swap the A and B signals from it as well.
The square wave output is not toggling until I turn the encoder backwards a step. Is this expected?
I am getting a sine wave out, but at a much lower frequency: setting at 1000Hz, I get a sinewave of 6.8Hz (after adding a 1uF cap). Is this expected?
Thanks!
David