J Well, bought a 'Genuine' Nano and tried this... 1. can't seem to run over 200HZ without hanging it. Checked everything..Assuming D14 is A0 and D15 is A1, it's all wired correctly. 2. why is this line in there: const int POT_pin = A2; Doesn't seem like it's used anywhere. and no wires are on A2. I think it was touchy before because of the encoder. Any ideas why yours does so much better than mine? My Nano is listed as "Arduino Nano [A000005] which should be v 3.x. Dec 24, 2018
Well, bought a 'Genuine' Nano and tried this...
1. can't seem to run over 200HZ without hanging it.
Checked everything..Assuming D14 is A0 and D15 is A1, it's all wired correctly.
2. why is this line in there: const int POT_pin = A2; Doesn't seem like it's used anywhere. and no wires
are on A2.
I think it was touchy before because of the encoder.
Any ideas why yours does so much better than mine? My Nano is listed as "Arduino Nano [A000005] which should be v 3.x.