Solar-Powered Robot Jellyfish Swims Through an Aquarium Using Only the Tank's Lights

User Avatar Aswinth Raj
Author
Share
Translucent Robot Jellyfish Swims in Aquarium Tank

Three years ago, designer Robert Skinner sketched an idea he admits was a bit stupid: an aquarium where every creature is a robot and everything runs on solar power, with no human intervention. He has now built the first resident, a translucent robot jellyfish whose bell is skinned with small solar panels. It sinks, gathers light from the lamps around the tank, and pulses its way back up, repeating the cycle on its own.

A solar engine in a clear dome

The jellyfish grew out of a simpler warm-up build, a walking "pet rock" robot named Rocky, where a solar panel charged a battery that simply ran a motor. That approach does not scale down. The panels that fit on a jellyfish bell cannot supply enough current to spin a motor continuously, so Skinner borrowed the idea behind BEAM robotics: store energy slowly, then release it in a burst.

His circuit charges a capacitor from the solar panels, uses a MOSFET as the switch that dumps that stored energy into the motor, and adds a Schottky diode so charge cannot leak back into the panels. The original plan was fully analog, with a comparator watching the capacitor voltage and firing the MOSFET at a set level. He could never get the MOSFET to switch cleanly, so he moved the decision to an ATtiny85. That gave him control over when the motor fires and for how long.

The bug every battery-free design hits

The first working run turned out to be powered by the programming cable he had left plugged in. Once it was removed, the circuit misbehaved, and it took him about two more days to find out why: the ATtiny85 and the motor shared one capacitor, so every time the motor pulled current the voltage collapsed and the microcontroller reset itself several times a second. Giving the controller its own separate capacitor fixed it. It is a lesson worth remembering for any energy-harvesting build, where the logic supply has to be protected from the load it is switching.

Making it swim like a jellyfish

The mechanical side took longer. Spinning tentacles and nautilus gears were dropped, stacked snail cams jammed instantly, and half gears pushed out unevenly. The design he settled on uses a saw-tooth cam that pushes brass rods outward together under a 3D-printed silicone skin that springs back to shape, squeezing water out like a real jellyfish. The final version uses five solar panels instead of the three he tested with, and bright lamps aimed low in the tank so the jellyfish always has enough power to climb back up.

Skinner is honest that powering solar panels from artificial light is comically inefficient. The point is the build itself: a robot that lives entirely on harvested light, with every part visible through its clear dome. If you want to start with a microcontroller like the one inside it, see our guide to programming the ATtiny85 over USB with the Digispark bootloader.

Image credit: Robert Skinner, frame from the maker's video, cropped and resized.

About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn

Have any question related to this Article?

Add a comment

No account needed. Your comment appears once a moderator has reviewed it.

Never shown publicly.
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.