Maker Builds a $10 ESP32 Smartwatch From Brass Tubing That Shows Phone Alerts

User Avatar Aswinth Raj
Author
Share
Huy Vector's ESP32 Smartwatch Made From Brass

Most DIY smartwatches end up as a dev board strapped to a wrist. Maker Huy Vector of HVT Lab went the other way: he built the case itself from bent and soldered brass tubing, so the electronics sit inside an open metal frame, and the finished watch shows phone notifications and incoming calls over Bluetooth. He puts the parts cost at under $10, and the build video passed 216,000 views in under two weeks.

What is inside

The parts list is short and easy to find:

  • ESP32-C3 Super Mini board as the brain, with Bluetooth LE built in
  • 1.3-inch 128 x 64 OLED (SH1106) for the watch faces
  • DS3231 RTC module so the time stays accurate even when the phone is not connected
  • A three-way toggle switch for up, select and down, plus a slide power switch
  • A small 3.7 V lithium battery and a charger board
  • 2 mm and 1.5 mm brass tubing, 1 mm wire and a standard 20 mm strap

The OLED and the DS3231 share one I2C bus (SDA on GPIO0, SCL on GPIO1), and the three buttons pull GPIO10, GPIO20 and GPIO21 to ground. Holding the middle button for 400 ms acts as Back.

How the brass frame is made

Huy cuts the tubing to length, bends it around the display and battery, and solders the joints with flux and a regular iron, no 3D printer or custom PCB needed. The frame doubles as the mount for the modules, and the strap lugs are soldered on the same way. At the end he brushes a protective coating over the electronics; the watch survived a short dip in a glass of water, though he stresses it is an experiment, not a certified waterproof watch.

Firmware: one click from the browser

The firmware, NWatch C3, is his ESP32-C3 rebuild of Zak Kemble's open N|Watch project. It uses the NimBLE Bluetooth stack and Apple's ANCS service to pull iPhone notifications and call alerts, syncs the date and time from the phone, and offers several animated watch faces. It installs from a web page over Web Serial in Chrome or Edge, so you do not need an IDE to flash it. The full wiring diagram and parts list are on his project page.

Why it is worth a weekend

It is the same brass-frame style he used for his pocket AI assistant. Every module here is a common part, so the build is mostly about patience with a soldering iron. If the DS3231 and OLED combination is new to you, our ESP32 real time clock project with DS3231 and OLED covers the same two modules on a breadboard first.

Image credit: Huy Vector / HVT Lab, frame from the build video, cropped and resized.

About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn

Have any question related to this Article?

Add a comment

No account needed. Your comment appears once a moderator has reviewed it.

Never shown publicly.
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.