The Emporia Vue 3 is a $199.99 energy monitor that clamps onto 16 circuits in a breaker panel and shows what each one costs to run. Out of the box, every reading goes through Emporia's cloud. LTT Labs has now documented how to cut it off from those servers completely by reflashing the ESP32 inside it with ESPHome, so the data never leaves the home network.
An ESP32 behind five test pads
The trick works because the Vue is built around an ESP32. Flaviu Tamas reverse engineered the earlier Vue 2 in 2021, and Maelstrom96 and krconv turned that work into ESPHome firmware that replaces Emporia's code. When the Vue 3 arrived with the same ESP32 and the same measuring chips, digiblur and Cossid brought support to it in 2024. Emporia shrank the board, swapped headphone-style clamp plugs for screw terminals and added Ethernet, but none of that changes the firmware.
There is no USB port. Five screws open the case, and five small gold test pads connect straight to the ESP32's serial port and boot pin. LTT soldered jumper wires to the pads (a spring-pin BDM clamp also works) and connected a cheap USB-to-serial adapter. Two details catch people out: on the Vue 3, RX goes to RX and TX to TX, the reverse of normal serial wiring, and the boot pin must be grounded before power-up to enter download mode.
Back up first, then flash once
Before flashing, the full stock firmware is dumped with one esptool command, read-flash 0 ALL, at 460,800 baud rather than the slow 115,200 default. That backup is the only way back to Emporia's firmware. A basic ESPHome image goes on over USB, and the full configuration for all the clamps is then pushed over Wi-Fi, so the case never needs opening again. The device must be fully disconnected from mains while it is open, and panel installation should be done by someone qualified.
The community has known fixes for the usual problems: I2C errors are solved by running the bus at 400 kHz with a 1 ms timeout, some circuits read negative until an absolute-value filter is used, and the default config writes to flash every minute, so raising flash_write_interval to 48 hours avoids wearing out the chip.
What the data showed
LTT ran a flashed Vue 3 in a heat-pump house in Quebec from March to September 2026. Over 205 days the home used 11,903 kWh, about 58 kWh a day, for roughly C$1,243. EV charging was the biggest single load at C$270, and the heat pumps came to C$263. One surprise: a heated bidet used more power than the washing machine. LTT estimates that cutting 10 kWh a day would pay back the monitor in about seven months.
Going local has one trade-off. Home Assistant stores the data at slightly lower resolution than the Vue produces. In return, nothing needs an account or a server in another country. If you would rather build a monitor from scratch, see our DIY ESP32 power consumption meter.
Image credit: LTT Labs, photo of the opened Emporia Vue 3, cropped and resized.
About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn
Add a comment
No account needed. Your comment appears once a moderator has reviewed it.