Most LED matrix builds sit on a desk. Maker Lorraine Underwood of element14 Presents had 60 old glass bricks sitting in her garage for four years, and turned them into a 6 x 10 pixel display set into her front garden, with 240 RGB LEDs, a Raspberry Pi Pico and a web page that lets the neighbours play Tetris on it.
From one brick to sixty
She started with no plan and no shopping list, which makes the video a useful record of the decisions a build like this needs. The first test used a micro:bit and a 30-LED strip under three bricks. The bricks glowed, but a flat strip could not bend to follow the grid and gave too little light per brick. She switched to bendable, waterproof string-style LED strips from a Pimoroni Plasma kit, and found that two LEDs per brick looked fine on camera but dim in person. Doubling to four LEDs per brick fixed that, which is where the 240 LEDs come from.
A wooden grid holds the bricks square and stops light bleeding from one brick into its neighbour, so each brick reads as one clean pixel. Because these strips cannot be chained, each of the six strips gets its own power, ground and data wiring back to the Pico, and part of the bring-up was simply working out which strip was on which GPIO pin in the code.
What went wrong
Power was the recurring problem. A chunky laptop-style supply runs the LEDs, but not at full brightness, and the first power-up only worked because the Pico was quietly running from USB. On the night of the first full test, three strips were blown after a board was connected the wrong way, and friends had to bring a spare strip so the display could be finished. Turning the brightness up in code made a big difference from the path.
Our take
Once it works, the result is lovely: colour fades, scrolling text, a Matrix rain effect and playable Tetris pieces, controlled from a phone over a web page served by the Pico. The lessons travel well to any large LED project: budget the power supply first, plan the wiring when strips cannot be daisy-chained, and test brightness in real viewing conditions. If you are new to addressable LEDs, see our guide to interfacing NeoPixel LED strips.
Image credit: element14 Presents / Lorraine Underwood, frame from the maker's video, cropped and resized.
About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn
Add a comment
No account needed. Your comment appears once a moderator has reviewed it.