Rigol DHO800 Oscilloscopes Can Now Boot an Open-Source Linux Firmware Written in Rust

User Avatar Aswinth Raj
Author
Share
Screenshot Of DHO924S Running OOS Cropped Resized

Rigol's DHO800 and DHO900 oscilloscopes are some of the most popular budget scopes on hobbyist benches. A developer known as dekajoule has released OOS, an "open operating system" that replaces the scope's software with a Linux 6.12 kernel and a completely new scope application written in Rust. It boots from the scope's own SD card alongside the stock system, and you can switch back at any time.

Rewritten from the outside in

OOS is an independent reimplementation rather than a patched copy of Rigol's firmware. The repository holds no vendor code or data. Instead, the project documents the scope's behaviour from the outside: register values, the words sent over the buses to the front ends, ADC, PLL and front panel on a running unit, the answers of the stock SCPI interface, and Rigol's public manuals and component datasheets. Each fact is labelled with how it is known: verified on the unit, assumed, or not yet tested on hardware.

Underneath, the scope is a Rockchip-based Linux board connected to an FPGA over PCIe, using the Xilinx XDMA driver. The OOS code on the scope depends only on Rust and the libc crate, with BusyBox as the userland. The project also credits the GPL kernel source published for NovaOS, another Linux port to the same hardware, as its starting point.

What it can already do

The feature list is long for a project that started this month:

  • Acquisition up to 1.25 GSa/s and 125 M points on one channel, with peak detect, averaging, high resolution, roll and scan modes
  • Twelve hardware trigger types, plus protocol triggers on decoded bus events and zone triggers
  • 35 automatic measurements, an FPGA frequency counter, 8 math channels with free formulas and mask testing
  • 26 protocol decoders, from UART, I2C and SPI to CAN-FD, MIL-STD-1553 and NMRA DCC
  • Spectrum, eye diagram and jitter, power and Bode analysis, plus HDMI output drawn on the GPU
  • Remote control through a web page, SCPI, VXI-11, SSH and MCP for AI assistants

Experimental, and the author says so

The developer's unit is a DHO924S, and a user has reported OOS running on a DHO804. Other DHO800 and DHO900 variants are prepared from the known model table but have not run it yet, and the DHO1000, HDO and MHO lines use different boards. The README is blunt about the risks. Installing with a second card means opening the scope and voiding the warranty. A bad write can destroy the factory calibration stored on the card. Option licences have needed re-entering after running OOS, and measurements made under OOS are not calibrated to any standard. Back up the original card first.

For owners of a DHO800 who like to understand their tools, it is a rare chance to see exactly how a modern digital scope's hardware is driven. If you are newer to scopes, our guide on measuring current with an oscilloscope is a good next step.

Image credit: dekajoule, screenshot of a DHO924S running OOS, cropped and resized.

About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn

Have any question related to this Article?

Add a comment

No account needed. Your comment appears once a moderator has reviewed it.

Never shown publicly.
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.