Most retro handhelds are emulators in a nice case. The VapourDeck is not. Sprite_tm wanted to stop thinking of PC motherboards as deep magic, so he designed his own 486 mainboard from scratch and put it in a Steam Deck-style handheld that runs old DOS games on a real 486 processor. The design files are public on Codeberg.
Why the 486, and how to talk to it
He picked the 486 partly for nostalgia and partly because Intel still published proper documentation for it back then. The prototype runs an Intel 486DX4-100, the last 486 Intel made, and a second board uses the pin-compatible AMD 486DX5-133, which runs cooler and faster. Both run from 3.3 V, which makes them much easier to use with modern parts than the earlier 5 V chips.
A 486 is just a CPU. It has no memory controller, no video and no peripherals, so everything goes through its 32-bit bus. The useful trick is that all the fancy features such as burst reads and cache modes are optional. Ignore them and the bus becomes a simple handshake: the CPU pulls the address strobe low, the peripheral does its work and signals ready.
FPGA and ESP32 do the rest
Instead of period chipsets, the board pairs the CPU with a Lattice ECP5 FPGA, an ESP32-S3, a Chips and Technologies F65545 laptop VGA chip and some RAM. The FPGA implements the RAM controller and the classic PC peripherals: the interrupt controller, timer, DMA and Sound Blaster logic, adapted from the open-source ao486 MiSTer project. Main memory is a 16-bit SDRAM, so each 32-bit bus access becomes two SDRAM accesses. Sprite_tm measures about 16 MB/s, roughly half of a typical 486 of the day, but the CPU's internal cache hides most of that in games.
The ESP32-S3 was chosen for its USB OTG port, which handles USB keyboards, mice and BLE gamepads, along with a micro-SD card for storage. It also loads the BIOS and video BIOS into SDRAM before releasing the CPU, so the board needs no ROM chip at all.
From desktop prototype to handheld
The first board was a desktop-style machine with VGA output, and Sprite_tm notes he got away with only a few bodges, including a VGA connector of the wrong gender that he soldered on the other side. The portable version adds lithium-ion power management with two 21700 cells and a 5.7-inch 640x480 IPS panel, a 4:3 size that is still manufactured and plugs directly into the VGA chip's parallel LCD output.
It is a rare full walkthrough of building a PC at the bus level, and a good reminder of how much an FPGA plus an ESP32 can stand in for. For another build that pairs an FPGA with an ESP32-S3 to extend retro hardware, see how an original NES got a desktop and a web browser.
Image credit: Sprite_tm / spritesmods.com, photo cropped and resized.
About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn
Add a comment
No account needed. Your comment appears once a moderator has reviewed it.