datasheet and information about 6c17504 and 1d17409 8pin ic

WhatsApp Image 2021-02-15 at 16.50.51 (1).jpeghi , i have a power supply of epson eb-x41 projector that doesn't turn on . i haven't found the problem yet but in the power supply circuit it has 2 ics that i couldn't find any datasheet or just a little data about them, i think they should be switching ics but it's so strange for me why there is no data about them?!

Epson uses custom made ICs fabricated from china in bulk quantities. This is a problem to get the actual data over internet. Did you getting proper power in the main board? Possibilities are power issue from the SMPS module.

Thanks.

  Joined February 12, 2018      696
Monday at 02:11 PM

thanks for your reply, i know the problem is power supply and dis board is power supply

WhatsApp Image 2021-02-15 at 16.50.51.jpegWhatsApp Image 2021-02-15 at 16.58.09.jpeg

  Joined February 16, 2021      5
Tuesday at 12:22 AM

Those ICs are FA8A01 and FA5612.

They fail rarely.

Do following things -

1. Check for fuses if they are destroyed, obviously if there are fuses only then you could check.

2. Check diodes if they failed.

4. The incliming wire with the white JST connector, are there sufficient voltage arriving? There should be DC voltage. What are the values?

If you are sure buy those. THey are not hard to find.

  Joined February 12, 2018      696
Monday at 02:11 PM

thanks, fuses are healthy and i think no one of the pins on the 10-pin output connector has voltages, because smps is off and it should get command from the main board from optocouplers. i should know how can i check if that command doesn't come or it exists and the smps doesn't work properly

  Joined February 16, 2021      5
Tuesday at 12:22 AM

It is marely difficult to state at this point as there is no proper schematic. Check with scope if possible but it is a laborious job.

  Joined February 12, 2018      696
Monday at 02:11 PM

thanks, i will try

  Joined February 16, 2021      5
Tuesday at 12:22 AM