A hoverboard that actually leaves the ground has been a maker dream since Back to the Future, and most attempts end up as either a wheeled scooter or a drone you stand near. YouTuber Jake Rogers has built a battery-powered mini hoverboard that floats over a copper sheet with no wheels, no propellers and no power cable, using nothing more exotic than two brushless motors spinning rings of permanent magnets. It is the first prototype on his way to a full-size board he can ride.
How it floats
The trick is eddy currents. A magnet moving fast over a good conductor induces circulating currents in the metal, and those currents create their own magnetic field that pushes back against the magnet. Spin enough magnets fast enough over copper and the push is strong enough to lift the motor that is spinning them.
Rogers started with a single brushless motor driven by an ESC and an ESP32, with a 3D-printed rotor carrying 12 magnets, held over a 6.35 mm copper plate. It lifted, but the reaction torque from the rotor made the whole assembly spin in the opposite direction. The fix was a second motor and rotor turning the other way so the two torques cancel. On the first try both motors were still spinning in the same direction, which he only noticed after the board kept turning.
His model of the rotor shows why ride height matters so much. At 4,000 RPM, the predicted lift per rotor is about 4.3 N with the magnet face 8 mm from the copper, but only about 0.9 N at roughly 15 mm. Speed is the other lever, but the load on each magnet grows with the square of speed, so doubling RPM puts four times the outward force on the rotor.
Cutting the cable
To go wireless, the board gained a buck converter for the ESP32, an IMU to report orientation, and Wi-Fi for commands and firmware updates. Power comes from two 3S LiPo packs in series for a 6S, 22.2 V nominal supply. The extra weight made lift harder, and the first layout was so unbalanced that dead batteries had to be added as counterweights. A redesigned chassis that puts the batteries between the motors solved it, and the electronics now sit inside a pink 3D-printed shell.
Our take
This is honest engineering: the board still needs a conductive surface and it can drift, and Rogers labels the modelled graphs separately from his physical tests. But it is a clear, buildable demonstration of induction, torque balancing and brushless motor control in one project. Some time back, we at CircuitDigest built a much simpler electromagnetic levitation device that uses a Hall sensor and a MOSFET to hold a magnet in the air, a good starting point for anyone curious about magnetic levitation.
Image credit: Jake Rogers, frame from the maker's video, cropped and resized.
About the author: Aswinth Raj is an electronics engineer and the editor of CircuitDigest, where he has published more than 150 hands-on projects and tutorials across Arduino, PIC, ESP32, Raspberry Pi and EV battery systems. He selects the stories on this page for what engineers and makers can actually learn or build from. Connect on LinkedIn
Add a comment
No account needed. Your comment appears once a moderator has reviewed it.