Modbus communication as slave using arduino

Submitted by Udit Kumar on Fri, 12/04/2020 - 13:09

Hello, I'm trying to make this project but in simply modbus software I'm unable to get response how I should check the fault.the link of the project is given below.

https://circuitdigest.com/microcontroller-projects/rs485-modbus-serial-…

Check the connection first. Are you using exactly same circuit? Did the code compiled properly?

  Joined February 12, 2018      696
Monday at 02:11 PM

Thankyou very much for responding

As in the project there are four major parts 1. arduino /2.LCD / 3. USB to RS 45 converter module/ 4. MAX485 TTL to RS-485  /5Servo motor . I'm not using servo motor , LCD interface is OK, Circuit Connections are OK, connections of USBRS485 and MAX TTL to RS is also correct. but i can't say whether they are working or not.

  Joined December 04, 2020      1
Friday at 10:09 AM