PIC18F23k22 interfacing with HC05

Hello

I am interfacing pic18f23k22 with HC05 bluetooth module through uart interface.if i send 'a' from bluetooth terminal app led must glow on and send some ok msg back to controller and if i press 'b' then led must off and send response back to pc.i have completed coding but i am not getting expected output so please help me to resolve this problem.i have also done hc05 setting through command mode.i am sharing my code please help me

//config file//

#include <xc.h>

/// CONFIG1H
#pragma config PLLCFG = ON // 4X PLL Enable->Oscillator multiplied by 4
#pragma config FCMEN = OFF // Fail-Safe Clock Monitor Enable bit->Fail-Safe Clock Monitor disabled
#pragma config PRICLKEN = ON // Primary clock enable bit->Primary clock enabled
#pragma config FOSC = INTIO67 // Oscillator Selection bits->Internal oscillator block
#pragma config IESO = OFF // Internal/External Oscillator Switchover bit->Oscillator Switchover mode disabled

// CONFIG2L
#pragma config PWRTEN = OFF // Power-up Timer Enable bit->Power up timer disabled
#pragma config BOREN = OFF //SBORDIS // Brown-out Reset Enable bits->Brown-out Reset enabled in hardware only (SBOREN is disabled)
#pragma config BORV = 190  //3 // Brown Out Reset Voltage bits->VBOR set to 1.90 V nominal

// CONFIG2H
#pragma config WDTPS = 32768 // Watchdog Timer Postscale Select bits->1:32768
#pragma config WDTEN = OFF // Watchdog Timer Enable bits->Watch dog timer is always disabled. SWDTEN has no effect.

// CONFIG3H
#pragma config CCP2MX = PORTC1 // CCP2 MUX bit->CCP2 input/output is multiplexed with RC1
#pragma config P2BMX = PORTB5 // ECCP2 B output mux bit->P2B is on RB5
#pragma config MCLRE = EXTMCLR // MCLR Pin Enable bit->MCLR pin enabled, RE3 input pin disabled
#pragma config CCP3MX = PORTB5 // P3A/CCP3 Mux bit->P3A/CCP3 input/output is multiplexed with RB5
#pragma config T3CMX = PORTC0 // Timer3 Clock input mux bit->T3CKI is on RC0
#pragma config PBADEN = OFF // PORTB A/D Enable bit->PORTB<5:0> pins are configured as digital I/O on Reset
#pragma config HFOFST = ON // HFINTOSC Fast Start-up->HFINTOSC output and ready status are not delayed by the oscillator stable status

// CONFIG4L
#pragma config XINST = OFF // Extended Instruction Set Enable bit->Instruction set extension and Indexed Addressing mode disabled (Legacy mode)
#pragma config LVP = ON // Single-Supply ICSP Enable bit->Single-Supply ICSP enabled if MCLRE is also 1
#pragma config STVREN = OFF  //ON  // Stack Full/Underflow Reset Enable bit->Stack full/underflow will not cause Reset
#pragma config DEBUG = OFF // Background Debug->Disabled

#define _XTAL_FREQ 16000000

//main.c //