I have the board and I have done some interfaces with it so far. Now I'm trying timers and interrupts, and I don't have an oscilloscope to examine square waves.
Is there any simulation software for it? or shall I use any cheap chip I have to develop some input capture software to work as an oscilloscope and interface it with TM4C123 ?
I can't afford one. The same
I can't afford one. The same situation as the oscilloscope.
Do you know any available simulator ?
Sourav Gupta
PermalinkI think logic analyser will do the job. Typically, it has three LEDs, two of them provide the logic 1 and logic 0 status separately. You could use it to check the square wave as high and low pulse depending on the frequency.
- Log in or register to post comments
Joined February 12, 2018 696Monday at 02:11 PM