Typical minimum radius for internal routing? AKA routing bit radius?

1 post / 0 new
Jacobcullen's picture

Offline

Joined: Feb 16, 2019

Replies: 0
Typical minimum radius for internal routing? AKA routing bit radius?
February 16, 2019 - 1:23pm

My fab house hasn't responded to this question yet and it's holding me up. (Probably due to Chinese new year but I thought it was over by now.) I'm trying to put addressable 5050 LEDs inside a circuit board but I'm worried about corner radius and if I need to overshoot the corners. I'm using PCBWay if anyone knows specifics.