Need some help accessing the programming of my electrical screwdriver that is malfunctioning.

So... I'm an electro student at and I took apart my electric screwdriver because it is turning off too quickly when high load is applied - I think it might be programmed incorrectly. I haven't really taken all the courses needed to be able to figure this stuff out by myself. Any help would be appreciated.

Basically, I want to access it's onboard storage and rewrite when it is supposed to stop. And also it would be cool to be able to read some information off it when it's spinning to see what type of information it measures.

This is what the electronics look like:



So from what I can gather there are 4 access points to the left and 6 to the right. How would I go about accessing and what gear do I need to purchase to do it?

https://i.imgur.com/om9wmX0.png

https://i.imgur.com/CMwaWmo.png

https://i.imgur.com/qjpRw4p.jpeg

Thanks for any input, even if it's satirical